Perma Stone Adhesive

TWO COMPONENT EPOXY PRODUCT USED FOR CREATING MECHANICAL KEY ON STONE BACK TO FACILITATE FIXING
DESCRIPTION

While fixing polished stones, huge granite or marble slabs, synthetic marble or granite slabs to the vertical surfaces, normal adhesives do not hold their weight, as these stones are too heavy and have a closed grained surface which is smooth. For this reason such slabs are either mechanically fixed with anchor fasteners or a mechanical key is created on the rear surface of the slabs, so that a general purpose adhesive can be used. Perma Stone Adhesive is used for creating mechanical key on the stone surfaces.

Perma Stone Adhesive

PRIMARY USES

Perma Stone Adhesive is mainly used for creating an effective mechanical key on the smooth stone surfaces.

DIRECTIONS FOR USE

Ensure that the surface of the stone or slab to be fixed to the wall is clean and free from dust, dirt, grease etc. Make sure that the surface is absolutely dry. Perma Stone Adhesive is a two-component product, consisting of Base and Reactor. Pour out the base and reactor components of the product into a clean pan and mix it thoroughly with a trowel to form an even colored and homogeneous consistency slurry. Brush apply this slurry on the back of the stone. Sieve out coarse grains from dry sand and sprinkle them evenly on to the surface and allow the slurry to dry off over night. Fix the stone to the wall with Perma SA as per the normal practice giving ample support till SA achieves sufficient strength.

ADVANTAGES

  1. Easy to use.
  2. Complicated mechanical fixing is avoided.
  3. Economical method of stone fixing.

PROPERTIES

Specific gravity : 1.60 at 25°C
Pot Life : 30 min at 35°C
Tack Free Time : 6 Hours at 35°C
Initial / Full Cure : 24 hours / 7 days
Coverage : 30 Sq. Ft / Kg

EQUIPMENT CARE

All equipment, tools and brushes must be cleaned immediately after use with Cleaning Solvents. If the material sets in the pan then pan and the brushes go waste. Similar procedures should be adopted for break periods exceeding 15 minutes. Avoid contact with skin.

PACKING

Perma Stone Adhesive is available in 500 gms in premeasured units.

SHELF LIFE

Perma Stone Adhesive has a shelf life of 12 months from the date of manufacture if stored in Manufacturer’s original packing in a cool and dry place away from moisture and heat.

DISCLAIMER

PERMA warrants that all products are free from any defects of manufacture and comply with the specifications given in their respective technical data sheet. No warranty can be given as to the results of use because conditions of use, such as site conditions, surface preparations, workmanship, weather, structural issues and other factors are beyond the control of PERMA. Purchaser agrees to seek the advice of qualified professionals to carry out tests & take trials to determine the suitability of products for their intended purpose prior to full scale usage of PERMA products and assumes all risks.

The company does not assume any liability for unsatisfactory results, arising from the use of our products. Purchaser’s sole liability is limited to replacement of product or refund of the purchase price paid if any product proven defective. No other warranties, express or implied, shall apply including any warranty of merchantability or fitness for a particular purpose.
PERMA shall not be liable for any consequential damages arising from the use of our products for unsatisfactory results.

The information supplied in this datasheet is based on our experience through extensive research and is given in good faith in order to help prospective users. We reserve the right to update the information provided in our technical data sheet at any time without prior notice within the scope of technical progress or new developments.